Lemond RevMaster Pro Manual do Utilizador

CHdlSiGidCam Handle Service Guide •Page 2. Introduction•Page 3. Troubleshooting guide•Page 4-5. Adjusting the clamp force•Page 6-7 Disassembling gr

How the cam handle worksThe head of the dipped handle has an eccentric surface. As the handle is pushed down, the head forces the post plunger assemb

Troubleshooting guideSymptom Possible Cause SolutionPost slips down with handle clamped down completely (0°)Clamp force adjusted too lightAdjust (inc

1. Lift handle up (90°) to fully release clamping forceAdjusting handle clamping force (From the factory the clamp should be set around 30-38 lbs to o

4. Tighten the M6x15 dome screw to secure pin position.5. Be sure that teeth are fully engages to prevent the ygg ppost handle pin from losing its pos

Replacing and re-greasing parts1. Disassemble handle assembly.Tools needed (1) 6mm hex, (1) 3mm hexDOME SCREW (M6 X 15)LOCK WASHERPOST HANDLE LIMITERP

NEW PIN(ALL AROUND CENTER AREA)NEW PLUNGER(CENTER OF PLATE)HANDLE(CAM SURFACE)Step 3Add grease to surfaces shownStep 4Step 4Reassemble – set clamp for

Replace post bearingsPOSTCASTING CAPADHESIVEPOST BEARINGSLEEVE RETAINERCASTING CAPStep 1 - DisassembleUndo post plug - Remove post - Remove cap and re

POST BEARING W/ ADHESIVEStep 3 – Install new post bearingPut new post bearing in aligning the tabs. Press bearing with adhesive against inside wall t